Learn more on proper nailing for vinyl siding installation how to install vinyl siding.
How tight to nail vinyl siding.
Simply go outside grab the lower edges of a siding course and try to slide it back and forth photo 1.
For the best results leave at least 1 16 inch between the nail head and the siding to give it some room to grow.
Vinyl siding can either be nailed by hand with a hammer or by a power nailer.
Also learn the right way to hang siding with insulation in mind.
An expert guide on the best way to nail vinyl siding either by hand or using a power nailer.
Vinyl siding that s nailed on too tight doesn t leave room for the materials to expand and contract and that causes ripples to form come summertime.
Between nail head and vinyl.
This will permit expansion and contraction as well as prevent dimpling which causes waves in siding.
To install vinyl siding to the soffit and fascia area on your home nail lengths of j channel along the inner edge of the fascia leaving the nail heads out about 1 32 to 1 16 of an inch.
Vinyl siding tends to expand and contract considerably with temperature changes.
Do not drive nails tight.
Tight nailing screwing or stapling will cause the vinyl siding to buckle with changes in temperature fig.
Following is a discussion of how to do both.
Next measure and cut the siding to fit the measurements of your soffit and push each panel into the j channel.
Integrated 1 thick eps rigid foam insulation nominal helps reduce utility costs and reinforces the siding.
Fully rolled over nail hem securely anchors panels to the wall.
For this reason manufacturers design it to hang loosely on the nails rather than to be tightly nailed like wood siding.
Allow approximately 1 16 in.
Drive nails straight and level.
The problem should be easy to diagnose.
Secure interlocking panel design provides a tight fit with no insulation gaps.
Do not nail to the extreme right or left of nail slot in siding panel.
Do not drive the head of the fastener tightly against the siding nail hem.